why is BPSK better than BFSK in presence of noise
Answers were Sorted based on User's Feedback
Answer / utsav_ju
actually the bandwith required for transn of signal using
BPSK is less than for BFSK.if we r planning to transmit a
digital data of say frequency f then the bandwith required
in BPSK is 2F while that in BFSK is 4f
Is This Answer Correct ? | 41 Yes | 6 No |
Answer / srajan tiwari
in bpsk the information is stored in the phase variations of the transmitted signal, and in bfsk , the info is stored in the freq variations., noise can affect the freq of signal but not the phase easily....so psk is better...........
Is This Answer Correct ? | 18 Yes | 6 No |
We have two types of fadng
1)frequency slective fading
2)flat fading
The noise will also occupy some frequency it may damage
the signal flately or frequency slectively. But in PSK
there is very less chance in the changing of phase f the
signal.
Hence for noisy channel PSK is better than FSK
Is This Answer Correct ? | 8 Yes | 5 No |
Answer / parth gupta
Although, it is observed through simulations that BPSK system
gives better bit error performance as compared to BFSK systems. But BFSK proves better in adjacent channel
interference conditions. Also mathematical derivations prove that BFSK approaches MSK (Minimum Shift
Keying) and MSK is the most suitable digital modulation scheme for power limited systems.
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / raghvendra
We know in bpsk the variation in signal change the phase of modulated signal and so the error and noise produced is low because of my practical result and in bfsk change in frequency is so rapidly and continuous and so resultant wave produced is more distorted.
Is This Answer Correct ? | 2 Yes | 5 No |
what is amplifire
Is a hole a fundamental particle in an atom?
Explain how to calculate knee point voltage? Describe its purpose for differential protection.
Define what is point contact diode?
what course we have to do for e&tc
In UMTS, which will control RRC protocol??
Is there any difference between the electronics and communication engineering and electronics engineering?
modern capacitors which have high capacitance in small size use a dielectric of?
Consider sinc(x):where sinc(x)=sin (xpi)/xpi. and sinc(x) have max value i.e. unity at x=0 .now if x=0.then pix =0 and sin (pix)=0 at x=0. then above expression sin (xpi)/xpi.should be of 0/0 form i.e. in-determined form. then how sinc(x) is one at x=0. pi is constant.
what is the purpose to give two power supply to opamp ie. +Vcc & -Vee?
what is the need for modulation?
What is skin effect?