Answer Posted / s.arul

yes, surely affected the glowing.
flurescent lamp in 50hz supply 20milli second one time
reached in zero position in sine wave (that time light not
glowing) that time is very less. in 25hz supply 40ms one
time reached in zero position that time light not full
brightness compared to 50hz supply.

why servomotor motor? where i apply for best output?

2038

---

How much no load current of synchronous motor

2098

---

What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?

1939

---

why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?

2148

---

There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?

1145

---

what is v/f control in VFD?

1552

---

What are the two basic types of transformers?

1173

---

In vapour absorption refrigeration machine fluids used are

1237

---

why normally Generator rating are between 11Kv to 22Kv?

4668

---

Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box

2097

---

what is induction furnance? how many phase supply given io its coil for 15 or 20 ton furnance?

3416

---

What is touch potential and step potential?

2160

---

1hp= how much rpm

2077

---

Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job

2161

---

I have 440v power coming to facility,( not being used ) can I buy large generator, (gas) to sell power back to electrical co.

2459

---