where can find the information on 2R manipulator?and wat is
the history of this 2r manipulator?
No Answer is Posted For this Question
Be the First to Post Answer
What is the units of surface tension and also dimensional formula?
best tip to increase fuel efficiency with a high powered engine?
wer r u coming from ,,,,
What is the torque required at M6, M8, M10, M12, M14, M16, M18, M20, M22, M24 Bolt or give me any chart for this?????????
how does an EDM works?
I have 1010 KVA Generator when i run the DG set for 5 to 6 hours the couplling (couplling joint in between engine & alternator) bolts are getting loose what is the reason & what is the remedy over this??????????
How to identify the bearing number with 3 dimensions of bearing ID & OD & bearing outer width? In interview me answerad only the bearing ID multiply with 5. That is last two digit number.
0 Answers Al Suwaidi, Shriram Pistons, SPIPL,
in power plant which pump is used for feeding the water a) centrifugal pump or b) reciprocating pump and why?
Tell us how do you discharge your duties in your duty post
0 Answers IES, Power Plant, Tata Teleservices,
1.how do you purchase the sheetmetal,machined components for OEMS? 2.WHAT IS THE SYSTEM TO BE MAINTAINE FOR PURCHASE ACTIVITY? 3.HOW DO U DO THE PRICE NEGOTIATIONS & ITS PROCEDURES? 4.WHAT ARE THE PROBLEMS WILL FACE WHILE PURCHASING THE COMPONENTS& WHAT IS THE SOLUTION TO OVERCOME BY THAT ONE 5.WHAT IS THE NECESSARY NOTES TO MAINTAIN THE PO& RELEASING THE PO?
If an ID Fan is designed for a suction pressure of - 250 mm wg and discharge pressure of +150 mm wg, and it is installed in a system where the required system resistance at suction is only -50 mm wg, will the ID Fan be able to produce a discharge pressure of +350 mm wg?
How should I begin a conversation that I need a change in the job to a known person in his organisation?