how to control ovality in internal diameter
Answer / sahebashekh
used spider in internal dia.
formulaof ovality:-%ovality =(D-d)/nominal dia * 100.
Is This Answer Correct ? | 6 Yes | 2 No |
how to work rack and pinion method
i having 7.5 kva 1 phase genset,coolant water level is low, so i mix the normal water this is correct or not
can we operate a deseal engine on outo cycle if no why??
what is tooth profile
Give five reasons why a reciprocating pump will reduce capacity or pressure when delivering water
WHAT IS A TR REQUIRED IF AIR FLOW 6500 CMH COIL INLET TEMP 7 - 12 DEGREE C AIR TEMP INLET - 18 DEGREE C & REQUIRED TEMP IS 12 DEGREE C
What is the hottest part of refrigerant in the refrigeration system?
wt is the difference between clutch and brake?
What is the difference betwn a tube and a pipe .
Where do railway steam engines carry there water?
Why do we use compressor in pumps for pumping water through borewells? Submersible pump is enough then why do we go for this method?
What do you understand by fuel cycle in nuclear plants ?