Answer / thiru

Embedded system is the combination of hardware and software
like c,c++,java, linux, Rtlinux ,pic,rtos etc. it is only
based on electronic devices washing machines,cell phones.
but Plc is only used for industrial automation like lifts,
high power loads automation.

Answer / pete poitra

No.
Embedded systems are intrisic to device or stand alone
control. However, as with cell phones, they become
networked but do not have influence on the operation of the
aggregate.

Why is the air gap between the pole pieces and the armature kept very small?

0 Answers  

---

Three phase power is measured with two wattmeeter for balance three phase load.the reading of one wattmeter is zero.we can conclude that the power factor of balance load is?

1 Answers  

---

how to calculate the capacitor rating for improving power factor

10 Answers   L&T, Property Solutions, Synergy, TAFE,

---

HOW MUCH KVA DG SET REQUIRED for charging 12v 4000 ah battery?

3 Answers  

---

for a 33/11kv transformer, after step down what happens to the balance 22kv.

2 Answers  

---

---

if acapacitor connected to power supply will it cosume power& will it going to get recorded in energy meter

2 Answers  

---

what is the operation of Control Module(CM),MONITOR Module(MM), MONITOR Module DUAL (MM2),Signal Module(SM),Isolator Module(IM), please some one reply me.. the operation and application of these in FIRE ALARM SYSTEMS...

1 Answers  

---

what is a difference b/w earthing & neutral?

5 Answers   ABB, KEC, Sterlite,

---

What is the basic of DTH.

0 Answers   IOCL,

---

What is transient response?

0 Answers  

---

1)What are the proccedure of initial charge of 100AH lead Acid battery bank 2)whether discharge test is reqd ? if it is rqd why, how 3)what are the discharge critieria (volt/cell or sp.gravity/cell

1 Answers  

---

. Why the transmission lines are in 11kV, 22kV, 33kv, and why not 10kV, 20kV, 30kV?

3 Answers  

---