How d.p. Transmitter can be applied to close tank?

0 Answers  

---

Q- What are the application in which PNP transistor is preferred over NPN ?

0 Answers  

---

How we are deciding while programming in pid controller , What we are using heating or cooling.

1 Answers  

---

what is the difference b/w wet leg & dry leg level method

2 Answers  

---

what is the difference between single and double compression cable gland

3 Answers   Petrofac,

---

Why do you want to work here

0 Answers   Eskom,

---

why we use 250 ohms across HART CALIBRATOR DURING CALIBRATION OF TRANSMITTER

4 Answers  

---

Questions on flow meters,few questions on HART protocol,

0 Answers   Monnet,

---

full process of gas turbin?

0 Answers  

---

i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure

0 Answers  

---

how u meassure room temp?is it possible 2 meassure room temp by rtd or thermocouple?between rtd n thrmocouple which is more regard?3 meassure diff. between rtd n thermocouple?

3 Answers  

---

I want to use 1/2 inch SS316 tube in my high pressure & temperature (64 kg/cm2 & 500 deg C)after condensate pot in pressure tranmistter. 1) Is it possible to use 1/2" ss316 tube in high pressure and temperature line. Tube manufacturer is local vendor. 2)On sarting the plant, We need to do system fluse that time condesate is not in the condesate pot so steam is directly contact with the tube. We have no exact calculation to know our tube is ok or nor at this time. pleae,reply.

1 Answers  

---