Interested to Buy Any Domain ? << Click Here >> for more details...
What are the some advantages of using Time Division
Multiplexing (TDM) as applied to commercial systems?
- 11 Answers
- 46624 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / prankster
In Tdm ....users use the same Bandwidth in turns ...a single
frequency channel divided into slots and users transmit in
slot allotted to them ...so same channel can be used by
different users ...its allows efficient Bandwidth utilization
| Is This Answer Correct ? | 62 Yes | 5 No |
Answer / visakh
In TDM, different users share the same channel based on
time slots alloted to them. Each user or source is given a
particular time slot to send its information.
Advantages:
1. The entire channel BW is available for a particular time
interval unlike in FDM where the channel BW is split into
smaller segments. This enables higher data rates.
2. All users share the same frequency, so spectrum
efficieny is increased. Available channel BW is no more a
constraint.
3. TDM is very useful since it takes advantage of the
bursty nature of voice signals. Voice data is not
continuous, it happens in bursts. Other users transmit data
during the slots of silence using TDM.
| Is This Answer Correct ? | 36 Yes | 5 No |
Answer / nithyalakshmi
less BW . the same freq. range can be used
| Is This Answer Correct ? | 43 Yes | 17 No |
Answer / amit
can be used in band limited for better efficiency
| Is This Answer Correct ? | 20 Yes | 5 No |
Answer / arindam ghosh as ani
Advantages of TDM-
1. Less bandwidth.
2. The same frequency range can be used.
3. It takes advantage of the bursty nature of voice signals.
4. Can be used in band limited for better efficiency.
| Is This Answer Correct ? | 5 Yes | 0 No |
Answer / phone guy
Are you asking about TDM -vs- IP for desktop commercial telephone systems? That would be a question I would like to talk about.
| Is This Answer Correct ? | 6 Yes | 2 No |
Answer / priyanshu
"In TDM we can transmit two signal simultaneously".We know
that in TDM every user can transmit with a given interval
of time during this time we can transmit another signal by
making the use of guard band time.
| Is This Answer Correct ? | 5 Yes | 4 No |
Answer / aasdeep singh
Fewer wires and simpler receiver used to transmit data from multiple sources to multiple destination, which makes TDM less in cost.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / mahara
utilization of BW is very important in any communication .so
this is efficiently done in tdm.
| Is This Answer Correct ? | 1 Yes | 2 No |
why the dc level shifting is required inlinear intigrated ckt?
What is meant by step-up and step-down chopper?
Define peak inverse voltage?
Define amplitude modulation?
What is Cycling Frequency Hopping?
Which is better in VLSI-NAND or NOR implementation? why?
Explain why we need biasing for transistor, fet and mosfet?
Draw a schematic diagram of a Half Adder. Can you draw the same using only NAND gates?
What is the function of DISTRIBUTION TRANSFORMER?
Dear i have to use camera in water so which type of camera wiil sutable?????
IS THERE ANY COADING PRESENT IN EPBX SYSTEM? IF YES THEN HOW WE CAN INSTALL IT?
full form of virus?
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
