Why sometime i receive GCU fault /Excitation voltage loss in my Generator Synch Panel .

1 Answers  

---

what is saturation? what role it plays in operation of ct's,motors etc and how its affects the behaviour of the same.

1 Answers  

---

how to reduce humming noise in transformer?

3 Answers  

---

Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1.  H1-H2 = H2-H3 H3-H1 2.  H2-H3 = H3-H1 H1-H2 3.  H3-H1 = H1-H2 H2-H3 For the LV side also: 4.  X1-X0 = X2-X0 X3-X0 5.  X2-X0 = X3-X0 X1-X0 6.  X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0  H2-H0  H3-H0    X0-X1  X0-X2  X0-X3 128.0  119.9  7.2      29.2   13.3   15.8 70.7   128.4  59.2     23.4   22.0   3.6 7.2    120.1  128.1    13.4   29.3   15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?

0 Answers  

---

How can we calculate the capacity of the capacitor bank attached with the Main panel, when we know the capacity of the panel installed in KVA Rating?

2 Answers  

---

What is stepper motor. What is its uses?

0 Answers  

---

In a 132KV Grid Station where voltage level is 132KV, here,  why the rating of Surge arrests installed 120KV ? 

1 Answers  

---

what is d meaning of inrush current of a trafo ? how u can calculate this ?

1 Answers   Jindal,

---

In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes

0 Answers  

---

what is deffrent alternatid and gernater

2 Answers  

---

why after termination of HT cable armoured earth connected one end, why not connect other end.pls tell me correct answer.

3 Answers  

---

how to select a breaker (MCB,MCCB,ELCB) for 18.5 kw, 3 ph. 480 v, 60 hz induction motor?

4 Answers  

---