Given the configuration example<HR> <B>interface ethernet0 ipx network 4a ipx access group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network 5c access list 800 permit 3d 4a</B><HR> Which two actions result from implementing this configuration? (Choose two) A. IPX network 5c will not receive any traffic B. Traffic from network 3d for network 4a will be forwarded out e0 C. Traffic from network 4a for network 3d will be forwarded out e0 D. Traffic from network 3d destined for network 4a will be forwarded out e2 E. The access list is applied to an outgoing interface and filters outbound traffic

1 Answers  

---

Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

1 Answers  

---

let there are three switch and there are 3 ree valn craed on each switch that is vlan 2 on first switch valn 3 on 2nd switch and vlan 4 is cretaed on switch 3 i have implemnted intervlan routin through ciso switchses. the router is conected through its fa0/1 port by one switch and and the two switch are trunked with each other now question is that we want to comuniacte betwwen vlan but does alse want that only vlan 2 is allow to access internet (ISP)which is conected through s0 interface of router.and no any vlan can access that internet.what should be solution.

1 Answers  

---

Which IP address and wildcard mask would you use in your ACL to block all the hosts in the subnet 192.168.16.43/28?

2 Answers   Siemens,

---

Utilizing RIP, what is the limit when it comes to number of hops?

0 Answers  

---

---

Identify the command to display all the valid commands at the given mode? A.) Help all B.) Help C.) All commands D.) ?

2 Answers  

---

Identify the 2 commands to copy a configuration from a TFTP server to RAM? A.) configure network B.) configure overwrite C.) copy backup-config running-config D.) copy tftp running-config

2 Answers  

---

Identify the 2 methods to modify the routers boot sequence? A.) Setup program B.) Boot system commands C.) RXBoot D.) Config-register

1 Answers  

---

What is a key use of a device hardware address? A. to obtain a vendor code / serial number from the user B. to transmit a frame from one Interface to another Interface C. to transmit a packet from one local device to another local device D. to transmit data from one local device to a remote device across the internet E. to contain logical information about the device to use for end-to-end transmission

1 Answers  

---

In IOS boot sequence if the flash is erased, and there is no access to TFTP server, and we can't load the partial IOS from ROM. Is there any possiblity that we can still boot the router/switch from external PC in which the IOS is installed?

6 Answers  

---

Which three protocols are correctly matched to their transport layer functions? (Choose three) A. route selection IP B. sliding window UDP C. well known pods IP D. route validation ICMP E. connection oriented TCP F. three-way handshake TCP G. no sequence and acknowledgement UDP

1 Answers  

---

How do you configure a cisco router for routing ipx?

0 Answers  

---