What is difference between IPv4 & IPv6??

7 Answers   Hathway,

---

Identify the OSI layer responsible for end-to-end connections? A.) Network B.) Transport C.) Session D.) Data link E.) TCP

4 Answers  

---

What is the routing algorithm used by RIP and IGRP? A.) OSPF B.) Link-state C.) Dynamic D.) Distance Vector

4 Answers  

---

what is hop count?

21 Answers   IBM, PalmChip,

---

The PDU at the network layer is a ________ Packet Frame Segment Bit

5 Answers  

---

---

Routers that have Flash memory typically have a ore loaded copy of place IOS software. Which command should you use to make a backup copy of the software image onto a given network server? A. copy flash tftp B. save copy to tftp C. write backup tftp D. write, backup -server-name- E. copy backup to -server-name-

1 Answers  

---

When using access lists, it is important where those access lists are placed. Which statement best describes access list placement? A. Put standard access lists as near the destination as possible. Put extended access lists as close to the source as possible. B. Put extended access lists as near the destination as possible. Put standard access lists as close to the source as possible. C. It isn't import where access lists are placed since the router will read and cache the whole list. D. Put access lists as close to corporate headquarters as possible.

1 Answers  

---

What is the juncture at which the CPE ends and the local loop portion of the service begins? A. Demarc B. CO C. Local loop D. Last-mile

1 Answers  

---

Default packet size of ipv6?

0 Answers  

---

How do you get help on a command after you have received the % incomplete command response from a switch CLI? A. type "history" to review the prompt before the error B. enter a question mark to display all the console commands C. type help followed by the command to see command parameters D. reenter the command followed by a question mark to view keywords

1 Answers  

---

Which is true regarding store-and-forward switching method? A.) Latency varies depending on frame-length B.) Latency is constant C.) It is default for all Cisco switches D.) It only reads the destination hardware address before forwarding the frame

1 Answers  

---

which is following route will be used to froword data in a situation where a routing table tables contains static ,RIP,IGRP routes destined to the same network with each set to its default administrative distance

9 Answers   HCL,

---