What is convergence time? A.) The update time B.) The time it takes to reload a router C.) The time it takes for a packet to reach its destination D.) The time is takes for all routers update their tables after a change takes place

1 Answers  

---

What is the Difference between Hub and Switch?

2 Answers  

---

What is a digital certificate?

0 Answers   CCIE,

---

Which of the following is a layer 2 device? A.) Switch B.) Bridge C.) Repeater D.) Hub

2 Answers  

---

Which command listed below sets the banner message when someone connects to the router? A.) message # B.) banner # C.) login banner # D.) description # E.) login description # F.) banner motd #

2 Answers  

---

Identify the purpose of the following command 'ip route 192.168.100.0 255.255.255.0 10.1.0.1' A.) Enabling a dynamic routing protocol B.) Creating a static route to the 10.1.0.0 network C.) Teaches the router about the distant network 192.168.100.0 and how it can be reached via 10.1.0.1 D.) Assigning the IP address 192.168.100.0 to an interface

1 Answers  

---

What is the syntax to use to configure the port on a Catalyst 5000 switch? A.) slot port/type B.) type slot/port C.) port slot/type D.) port type/slot

1 Answers  

---

When you cords an IP address on a place router which command stale the IP processing on the interface? A. ip enable B. network ip-address C. ip address ip-address subnet mask D. the exit command from the enabled configuration E. copy running-configuration to startup-configuration

3 Answers  

---

Which of the following are Distant Vector protocols? A.) IGRP B.) RIP C.) OSFP D.) EIGRP

1 Answers  

---

hi shain/sudeep and rest of all plz answer these question for help some one as soon as possible what is stub area what is transit area let there are three area in ospf a0 a2 and a3 if a2 and a3 is coneted through each other will they comnicate

3 Answers  

---

Identify the correct IGRP configuration? A.) Router# router igrp 100 Router# network 10.0.0.0 B.) Router(config)# router igrp 100 Router(config-router)# network 10.0.0.0 C.) Router(config)# router igrp Router(config-router)# network 10.0.0.0

1 Answers  

---

Which address or number is used to pass the data to the correct application? MAC Number IP address Port Number Segment Number

2 Answers  

---