Answer / guest

Answer: C

Answer / m haja bahurudeen

Ans : C

Network layer determine best path because L3 device is
router. Router determine the best path to reach the
destination netwrok.

How do you find valid hosts in a subnet?

0 Answers  

---

How do you disable CDP on the entire Router? A.) Router#no cdp run B.) Rotuer(config-if)# no cdp enable C.) Router(config)# no cdp enable D.) Router(config)# no cdp run

1 Answers  

---

What are the disadvantages of symmetric algorithms?

0 Answers   CCIE,

---

Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router router?

0 Answers  

---

Which range of possible numbers do standard ipx access lists have? A. 100 199 B. 600 699 C. 800 899 D. 1000-1099

1 Answers  

---

Which 2 commands shows the Cisco IOS filename? A.) show IOS B.) show ver C.) show flash D.) show mem E.) show NVRAM

1 Answers  

---

Which statement about switched and routed data flows is correct? A. Switches create a single collision domain and a single broadcast domain. Routers provide separate collision domains B. Switches create separate collision domains but a single broadcast domain. Routers provide a separate broadcast domain C. Switches create a single collision domain and separate broadcast domains. Routers provide a separate broadcast domain as well D. Switches create separate collision domains and separate broadcast domains. Routers provide separate collision domains

1 Answers  

---

What is subnetting and supernetting and its uses?

4 Answers   HCL,

---

What three occurrences will reset the holddown timer after a triggered update? A.) Infinity is finally defined as some max number B.) HD Timer expires C.) Another update is received indicating a better metric D.) The router receives a processing task proportional to the number of links in the internetwork E.) The router detects fault LSP's propagating through the internetwork F.) Another update is received indicating net status changed

1 Answers  

---

When setting up a frame-relay network between a Cisco router and a non-Cisco router, what encapsulation type should you use? A.) SAP B.) CISCO C.) IANA D.) Apollo E.) IETF F.) Q933A

2 Answers  

---

Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers   Karrox,

---

What are 3 ways to provide login access to router? A.) Console B.) TFTP C.) Rlogin D.) Auxiliary Port E.) X Windows F.) Telnet

2 Answers  

---