how many vlan can be configured on a single switch

12 Answers   IBM, Sigma IT,

---

Identify the 2 commands to copy a configuration from a TFTP server to RAM? A.) configure network B.) configure overwrite C.) copy backup-config running-config D.) copy tftp running-config

2 Answers  

---

What is EIGRP?

0 Answers  

---

I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

5 Answers  

---

Identify 3 IP applications? A.) AURP B.) ARP C.) Telnet D.) SMTP E.) DNS F.) RARP

2 Answers  

---

What is the administrative distance for RIP? A.) 100 B.) 90 C.) 120 D.) 110

3 Answers  

---

Which memory component on a Cisco router contains the dynamic system configuration? ROM NVRAM Flash RAM/DRAM

17 Answers   HCL, Sun TV,

---

HI ALL! RECENTLY I COMPLETED MY MCITP, CCNA COURSE, I AM PLANNING TO DO CCNA CERTIFICATION, ANYBODY PLZ SUGGEST ME HOW MUCH TIME (MONTHS) REQUIRED TO PREPARE FOR CCNA, BOOKS, JOB SCOPE IN INDIA, QUALIFICATION REQUIRED, ANY JOB FOR FRESHERS? YOUR GOOD ADVISE IS HIGHLY APPRECIATED. Reg.Khaleel

2 Answers   IBM,

---

How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets

2 Answers  

---

Which statements are true regarding half duplex? A.) Only works in a point-to-point configuration B.) Allows for transmitting and receiving but not at the same time C.) Allow for transmitting and receiving of data simultaneously D.) Doubles the bandwidth

2 Answers  

---

which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..

3 Answers   Wipro,

---

What is the command to allow you to type Tokyo instead of the IP address 172.16.30.1 to access a router named Tokyo? A.) config t, ip host Tokyo 172.16.30.1 B.) config t, ip hostname Tokyo 172.16.30.1 C.) config t, hostname Tokyo 172.16.30.1 D.) config t, ip hostname 172.16.30.1 Tokyo

2 Answers  

---