Answer / guest

Answer: C D E

NetBios and IPX are not layer 3 IP protocols. IP - Internet
Protocol,

ARP - Address Resolution Protocol and RARP - Reverse Address
Resolution

Protocol.

what hapeen we we configure default root on the router which is conected by isp supoese there are two router r1 is conected throug isp and and by s0 r1 is conexted to r2 if we apply degault root on r1 what will happen

3 Answers  

---

What is true about Link-State protocols? A.) They maintain a more complex table than distant vector protocols B.) They maintain a less complex table than distant vector protocols C.) They use routing ports D.) The maintain backup copies of the IOS

2 Answers  

---

Which command displays the IP addresses assigned to specific host names? A. show hosts B. show interface C. ping host name D. config host name E. show host mapping F. show host ip address G. trace ip addresses host name H. a partridge in a pear tree

2 Answers  

---

Which protocols do periodically updates?

0 Answers  

---

What are the 2 functions of the Data Link Mac layer? A.) Handles access to shared media B.) Manages protocol access to the physical network medium C.) Provides SAPs for higher level protocols D.) Allows multiple devices to uniquely identify one another on the data link layer

1 Answers  

---

You have typed "ping" 172.16.101.1 and get the following display: Type escape sequence to abort. Sending 5, 100-byte ICMP Echoes to 172.16.101.1, timeout is 2 seconds: .!!!! What does the "." signify? A. That one message timed out. B. That all messages were successful. C. That one message was successful. D. That one message completed in under the allotted timeframe.

1 Answers  

---

Identify 2 features of X.25? A.) Supports only IP B.) Utilizes switched and permanent virtual circuits C.) Contains minimal flow control and error recovery D.) Utilizes LAPB as it's data-link protocol

4 Answers  

---

The Cisco IOS is stored where? A.) ROM B.) CD C.) Flash D.) NVRAM

1 Answers  

---

What is the difference between RIP & RIPng???? Can anyone explain it..!!! Thank u in advance.

1 Answers  

---

Which two statements are true? (Choose two) A. Ethernet 802.3 utilizes a half duplex method for data transfer B. In a 100 MBS point to point connection a full duplex connection can provide 400 Mbs of data transfer C. Ethernet switches can use the full duplex mode to connect multiple nodes on a single pod of a switch D. Full duplex Ethernet takes advantage of UTP using one pair for transmission and the other pair for reception

1 Answers  

---

Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom

1 Answers  

---

What is the ieee standard for wireless networking?

0 Answers  

---