Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the purpose of the TCP 3 step handshake?
A.) Setup a un-reliable connection
B.) Initialize routing tables
C.) Synchronize sequence numbers between hosts
D.) Connection tear down process
- 1 Answers
- 4326 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: C
The 3 step handshake establishes the parameters required for
a TCP
connection. During the handshake process sequence numbers are
synchronized allowing for the end points to properly
acknowledge and
re-assemble the segments.
| Is This Answer Correct ? | 5 Yes | 0 No |
Which command can verify only Network layer connectivity between 2 hosts? A.) ping B.) e-mail C.) plp D.) arp E.) telnet
Which service uses telephone control messages and signals between the transfer points along the way to the called destination? A. Signaling System 7 (SS7) B. Time-division Multiplexing (TDM) C. X.25 D. Frame relay
How many types of router?
can we measure how much a host exact bandwidth using by a network cable which is communicating over the network? options: 1- via Router 2- Switch, 3- other device... if yes.. then how ( with every option)
Which type of switching reads just the address portion of the frame and then immediately starts forwarding it? A.) Cut-Through B.) Store-and-Forward C.) Tabling D.) Routing E.) Inverse ARP F.) Fast Forward
how we update the IOS version with the help of TFTP?
Which dynamic type draw back is, if single link down, it removes its routing table?
Identify the IPX standard access-list number range? A.) 600 - 699 B.) 1000 - 1099 C.) 1 - 99 D.) 100 - 199 E.) 800 - 899
Which command would show all Ethernet interfaces with IPX configured on them? A.) show interface ipx ethernet B.) show ipx interface C.) show ipx interface ethernet D.) show ipx E.) show version F.) show run
Explain what is the size of hello packets in eigrep protocol?
Hi I asking one thing that my company having cisco ip phone with connected to cisco poe switch.But sometime when my agent calling to customer on that time customer voice is break only few 2 to 3 sec.I have already checked my wan link by isp and also lan connection,but this problem is not sorted out so pls help me.
Which command would configure Interface E0 with an IP address of 12.23.4.5 using a Subnet mask of 255.255.255.0 ? A.) ip address 12.23.4.5 255.255.255.0 B.) ip address 12.23.4.5 /24 C.) ip address 12.23.4.5 mask 255.255.255.0 D.) ip address 12.23.4.5 mask ff:ff:ff:0 E.) that is an invalid mask for a class 'A' address
CCNA 
