Answer / boby k

Network address is a IP address, used to identify on which
network the given IP belongs to. It uniquely identifies each
network. To find out correct network address we should know
the range of different classes of IP address. I suggested
please refer the text book "Todd Lamle" for more.

Answer / s.m.feroz ahmed

HI,

Network Address is defined as Ethernet Address the address
of LanCard which is alpha numeric and can be viewed through
command ipconfig /all and ethernet address is Network
address.

What is Route Poisoning?

0 Answers  

---

why we use AS no. in IGRP and EIGRP?

2 Answers   HCL,

---

Given the IPX address 4a.0002.1111.a999, what is the network ID and what is the node ID? A.) net 4a host 0002.1111.a999 B.) net a999 node 0002.1111 C.) net 0002.1111.a999 node 4a D.) net 0002.1111 node a999

1 Answers  

---

What is the UDP datagram format? A. Source Port - 16 bits, Destination Port - 16 bits, Length - 16 Bits, Checksum - 16 bits, Data B. Destination Port - 16 bits, Source Port - 16 bits, Length - 16 Bits, Checksum - 16 bits, Data C. Source Port - 16 bits, Destination Port - 16 bits, Checksum - 16 Bits, Length - 16 bits, Data D. Source Port - 8 bits, Destination Port - 8 bits, Length -8 Bits, Checksum - 8 bits, Data

1 Answers  

---

What is the command for change serial cost?

0 Answers  

---

What is the default interval for SAP updates? A.) 60 seconds B.) 15 seconds C.) 30 seconds D.) 120 seconds

1 Answers  

---

What is the purpose and default value of the CDP timer command? A.) 90 seconds; interval before an entry expires B.) 60 seconds; interval between updates C.) 60 seconds; interval before an entry expires D.) 90 seconds; interval between updates

1 Answers  

---

Explain the difference between static and dynamic routing?

0 Answers  

---

Identify the components in the following command 'interface serial0/1/1' A.) Serial interface, port number 0, slot 1, port adapter 1 B.) Serial interface, slot 1, port number 1, port adapter 0 C.) Serial interface, slot 0, port adapter 1, port number 1

2 Answers  

---

7. What is an advantage to using switches in your network? A. Addressing of hosts by DHCP B. Ease of administration C. Stops broadcast storms D. Works like a repeater

2 Answers   iGate,

---

Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) Booter load D.) RAM E.) Flash

4 Answers   Wipro,

---

When discussing static routes, what is the gateway parameter used for? A.) Determining the dynamic route B.) Defining the subnet C.) Defining the Administrative Distance D.) Determining the next hop

1 Answers  

---