Which line from a show spantree 1 command output indicates that virtual LAN 1 (VLAN1) is functioning properly? A. Root pod is FastEthernet 0/26 B. Port Ethernet 0/1 of VLAN1 is Forwarding C. Designated port is Ethernet 0/1, path cost 10 D. Designated root has priority 0 address 00D0 588F B600 E. VLAN1 is executing the IEEE compatible Spanning Tree Protocol

1 Answers  

---

can we configure multiple as on single router using eigrp

1 Answers   IBM,

---

Which command we use for ping in ipv6?

0 Answers  

---

Identify the correct pair of Novell Ethernet encapsulation and Cisco terminology? A.) Ethernet II, Snap B.) Ethernet 802.3, Novell-Ether C.) Ethernet SNAP, Arpa D.) Ethernet 802.2, Snap

1 Answers  

---

Which of the following will apply IPX sap access list 1010 for incoming traffic, assume you are at the interface configuration? A.) ipx input-sap-filter 1010 in B.) ipx input-sap-filter 1010 C.) ipx access-group 1010 in D.) ipx access-list 1010 in

1 Answers  

---

hi all.. can any one explain the complete topology of stp and rstp how it works . root swtch connects to a root port and then root port conenct to other switchs designated port. i was going thru his site http://www.cisco.com/en/US/tech/tk389/tk621/technologies_whi te_paper09186a0080094cfa.shtml in which DR also exist on root switch only which makes my understanding grim.I had a diff notion of stp all together. please post asap. and if possible refer a url so thst i can read it my self .. thanks

1 Answers  

---

CSMA/CD stand for which of the following? A.) Carrier Sense, Multiple Access with Collision Detection B.) Collision Sense, Multiple Access with Collision Detection C.) Collision Sense, Multiple Access with Carrier Detection D.) Carrier Sense, MAC address with Collision Detection

1 Answers  

---

Which OSI layer provides mechanical, electrical, procedural for activating, maintaining physical link? A.) Presentation B.) Network C.) Application D.) Physical E.) Transport F.) Data-Link

2 Answers  

---

Explian what is a node?

0 Answers  

---

Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network

3 Answers  

---

What are the advantages of lan switching?

0 Answers  

---

Which 3 statements describe default encapsulation and LMI type configuration? A.) There are only 4 encapsulations and 3 LMI type options B.) The LMI type config term options C.) In release 11.2 the LMI type is autosensed D.) The default LMI is Cisco E.) IETF encapsulation must be configured unless the connecting routers are both Cisco

1 Answers  

---