Answer / guest

Answer: D

Answer / kunal

d

What IP command would you use to test the entire IP stack? A.) Stack-test B.) Arp C.) Telnet D.) Ping E.) Trace

2 Answers  

---

What will transport layer do when data coming from session layer. They asked about intial operation(3 - way handshake)

1 Answers   HCL,

---

Explain the difference between static and dynamic routing?

0 Answers  

---

What is VLSM? how to Calculate VLSM? where it is use and why?

13 Answers  

---

Where is the point between the customers site and the phone carrier that responsibility changes? A.) CO B.) Demarc C.) DCE D.) DTE E.) CPE

1 Answers  

---

Given an IP host address of 172.16.2.160 and a shored mask of 255.255.255.192 to which shored does the host belong? A. 172.16.2.32 B. 172.16.2.64 C. 172.16.2.96 D. 172.16.2.128 E. 172.16.2.192

2 Answers  

---

What does the acronym ARP stand for? A.) Address Resolution Phase B.) ARP Resolution Protocol C.) Address Resolution Protocol D.) Address Recall Protocol

2 Answers  

---

Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP

4 Answers  

---

What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network

1 Answers  

---

Which of the following is a characteristic of a switch, but not of a repeater? A.) Switches forward packets based on the IPX or IP address in the frame B.) Switches forward packets based on the IP address in the frame C.) Switches forward packets based on the MAC address in the frame D.) Switches forward packets based only on the IP address in the packet

2 Answers  

---

When using access lists, it is important where those access lists are placed. Which statement best describes access list placement? A. Put standard access lists as near the destination as possible. Put extended access lists as close to the source as possible. B. Put extended access lists as near the destination as possible. Put standard access lists as close to the source as possible. C. It isn't import where access lists are placed since the router will read and cache the whole list. D. Put access lists as close to corporate headquarters as possible.

1 Answers  

---

Identify command that configures 'Cisco1' as a secret password? A.) Router(config)# enable secret password Cisco1 B.) Router(config)# enable secret cisco1 C.) Router(config)# enable password Cisco1 D.) Router(config)# enable secret Cisco1

2 Answers  

---