Interested to Buy Any Domain ? << Click Here >> for more details...
Which types of packets used in EIGRP?
- 1 Answers
- 4170 Views
- I also Faced
- E-Mail Answers
Answer / vikramsingh11
EIGRP uses five types of packets-- 1-Hello packets(multicast)
2-Updates packets
3-Acknowledge packets
4-Query packets
5-Reply packets
In EIGRP use three different tables--
1-Neighbours table
2-Topology table
3-Routing table
EIGRP discover the neighbours with the help of Hello
protocols and communication via RTP(Reliable Transfer
Protocol)...........
| Is This Answer Correct ? | 4 Yes | 1 No |
What is ping utility?
What is difference between fast ethernet and ethernet port?
13 Answers Bank of Baroda, Bank Of India,
I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
A router blocks ___________ Broadcasts Unicasts All packets Nothing
How many types of nat?
What two types of PPP data compression are available using Cisco IOS? A.) Predictor B.) DoubleSpace C.) Stacker D.) PAP E.) ZIP F.) CHAP
Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make fowarding decision using MAC address E.) Create collision domains
Which IP packet field will prevent endless loops? type-of-service identificationf lags time-to-live header checksum
What does synchronization mean?
How would you set the clock rate to 64K, on interface serial 0, from the interface configuration mode? A.) clock rate 64000 B.) bandwidth 64 C.) clock 64 D.) rate 64 E.) clock rate 64k F.) clock rate 64
When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?
What are the differnt memory use in cisco router?
CCNA 
