What route entry will be assigned to dead or invalid route in case of RIP?
No Answer is Posted For this Question
Be the First to Post Answer
Which technologies listed below help prevent network loops in a switched (bridged) environment? A.) Store-and-Forward B.) IEEE 802.1d C.) Diikjstra Algorithm D.) Cut-Through E.) Spanning Tree Protocol F.) Routing
Identify the correct pair of Novell Ethernet encapsulation and Cisco terminology? A.) Ethernet II, Snap B.) Ethernet 802.3, Novell-Ether C.) Ethernet SNAP, Arpa D.) Ethernet 802.2, Snap
What is the Difference between Hub and Switch?
Which command enables directly connected network 199.55.72.0 to be used by RIP? A. Router(config router)# rip 199.55.0.0 B. Router(config router)# rip 199.55.72.0 C. Router(config router)# network 199.55.0.0 D. Router(config router)# network 199.55.72.0
Mention what is the matric of eigrp protocol?
What does the Frame Relay switch use to distinguish between each PVC connection? A. data-link connection identifiers (DLCIs) B. BECNs C. FECNs D. the Local Management Interface (LMI)
In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physical interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay
How many hop counts are by default and how much you can increase in eigrp protocol?
What is the Function of Router?
Name the vtp modes?
Given the command 'cl?', what will it display? A.) Syntax of the 'clock' command B.) Syntax of the 'clear' command C.) All commands that begin with 'cl' D.) All commands that begin with 'c'
Which is true regarding store-and-forward switching method? A.) Latency varies depending on frame-length B.) Latency is constant C.) It is default for all Cisco switches D.) It only reads the destination hardware address before forwarding the frame