Which command sets IGRP as the routing protocol for autonomous system 100? A. Router(config)#igrp 100 B. Router(config)#network 100 C. Router(config)#router igrp 100 D. Router(config)#enable igrp 100

1 Answers  

---

Tell me which protocol comes under hybrid dynamic type?

0 Answers  

---

You have typed "ping" 172.16.101.1 and get the following display: Type escape sequence to abort. Sending 5, 100-byte ICMP Echoes to 172.16.101.1, timeout is 2 seconds: .!!!! What does the "." signify? A. That one message timed out. B. That all messages were successful. C. That one message was successful. D. That one message completed in under the allotted timeframe.

1 Answers  

---

What is the default LMI type? A.) Cisco B.) ANSI C.) IETF D.) Q933a

2 Answers  

---

My ccna certification is allready expried but I could not apper the ccnp exam due to some personal problem. Currently i am working as network administrator .Can it create any problem for my next job . and how can i apper he ccnp exam. Please help me and give me what is the solution.

1 Answers   PCS,

---

With one method for transmitting frames through a switch, the switch receives the complete frame and checks the frame CRC before forwarding the frame. What is the switch transmission method called? A. CSMA/CD B. Full Duplex C. Cut-Through D. Half-Duplex E. Fragmentation F. Store and Forward

2 Answers  

---

Which layer defines the physical topology? A.) Application B.) Transport C.) Network D.) Data Link E.) Physical F.) Session

1 Answers  

---

plz send me cisco contact no india?

0 Answers   3i Infotech, Cisco,

---

What is the passive topology in ccna?

0 Answers  

---

Which layer is responsible for coordinating communication between systems? A.) Application B.) Network C.) Session D.) Transport E.) Physical F.) Data Link

2 Answers  

---

You want to enable both arpa and snap encapsulation on one router interface. How do you do this? A. The interface can handle multiple encapsulation types with no extra configuration. B. Assign two network numbers, one for each encapsulation type. C. Enable Novell-ether to run multiple encapsulation types. D. Both arpa and snap are enabled by default so you don't have to configure anything.

2 Answers  

---

Which addresses are INCORRECTLY paired with their class? A. 1 to 126, Class A B. 128 to 191, Class A C. 1 to 126, Class B D. 128 to 191, Class B

3 Answers  

---