Interested to Buy Any Domain ? << Click Here >> for more details...
You have typed "ping" 172.16.101.1 and get the following
display:
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echoes to 172.16.101.1,
timeout is 2 seconds:
.!!!!
What does the "." signify?
A. That one message timed out.
B. That all messages were successful.
C. That one message was successful.
D. That one message completed in under the allotted
timeframe.
- 1 Answers
- 8301 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A
The possible responses from the ping command are:
! Successful receipt of an echo reply.
. Timed out waiting for a reply
U Destination unreachable
C Congestion-experienced packet
I Ping interrupted
? Packet type unknown
& Packet TTL exceeded
| Is This Answer Correct ? | 4 Yes | 0 No |
Layer 1 and Layer 2 devices must forward a broadcast. Which of the following devices fall into this category? Gateway Switch Router All of the above.
What is VLSM? how to Calculate VLSM? where it is use and why?
What is the last step in data encapsulation? A.) User information is converted into data. B.) Segments are converted into datagrams and packets. C.) Frames are put into bits. D.) Data is converted into segments. E.) Packets are put into logical frame.
What are partial updates?
Why is network segmentation a good idea when managing a large network?
What is the icmp protocol?
Of the following switching types, which one has the highest latency? A.) Cut-through B.) None C.) Store-and-forward D.) Fragment Free
Identify the protocol to test connectivity without configuring any layer 3 protocols? A.) TCP B.) Ping C.) IP D.) CDP E.) Telnet
Hello Every one. Can anyone please explain me the 7 OSI Layers with some general example? I am trying to learn it from last few months but i cant i realy need it. Thanks
What command can be used to test IPX connectivity? A.) Ping 2e.000.0045.8923 B.) Ping 192.168.100.1 C.) Ping ipx 2e.0000.0045.8923 D.) Ipx ping 2e.0000.0045.8923
I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used
What metric does rip use? How is the metric used to indicate an unreachable network?
CCNA 
