What is a vlan?

0 Answers  

---

What is VLSM? Why we Create? When we Create? Implement VLSM with example?

9 Answers   HP,

---

Which command displays the IPX SAP table? A.) show ipx sap B.) show sap C.) show ipx interface D.) show ipx servers E.) show ipx

1 Answers  

---

Identify 2 functions of IPX access-lists? A.) Control SAP traffic B.) Limit number of Novell servers on a network C.) Limit number of workstations on a network D.) Block IPX traffic

1 Answers  

---

Which command do you use to set the Secret password to 'roundwood'? A.) enable login roundwood B.) enable password roundwood C.) enable privilege roundwood D.) enable secret= roundwood E.) enable secret login roundwood F.) enable secret roundwood

1 Answers  

---

Which three are typical operational phases in a basic connection oriented network service? A. call setup B. data transfer C. load balancing D. call termination E. caller ID F. call prionflication G. data segmentation H. data and momma I. data link identification J. callering book

1 Answers  

---

Eight stations connected to separate 10 Mobs pods on a Layer 2 switch will give each station how many Mobs of bandwidth? A. 1.25 B. 4 C. 16 D. 10 E. 80

1 Answers  

---

hello friends im murtaza frm indore... and my question is that im doing hardware engenering and networking and im intrested in make a good career in networking so can you suggest.. which institiue is good for me...plzzz replyy im waiting...

1 Answers  

---

How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain

3 Answers  

---

What is the default switching method for the Cisco 5000 series? A.) Cut-through B.) Store-and-splice C.) Latency D.) Store-and-forward

1 Answers  

---

Which command will display adjacent routers found by the Cisco Discovery Protocol? A.) show all B.) show cdp entry C.) show ip neighbors D.) show cdp neighbor detail E.) show cdp neighbor F.) show neighbor

2 Answers  

---

Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#

3 Answers  

---