Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp

1 Answers  

---

After how long eigrp protocol advertise its routing table?

0 Answers  

---

What does the ping response & mean? * A: unreachable * B: congestion * C: user interrupt * D: unknown packet type * E: lifetime exceeded

6 Answers  

---

What does the trace response !H mean? * A: Network unreachable * B: Not forwarded due to ACL restriction * C: Protocol unreachable * D: Port could not be reached

2 Answers  

---

hi all.. can any one explain the complete topology of stp and rstp how it works . root swtch connects to a root port and then root port conenct to other switchs designated port. i was going thru his site http://www.cisco.com/en/US/tech/tk389/tk621/technologies_whi te_paper09186a0080094cfa.shtml in which DR also exist on root switch only which makes my understanding grim.I had a diff notion of stp all together. please post asap. and if possible refer a url so thst i can read it my self .. thanks

1 Answers  

---

Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecting to non-Cisco equipment C.) You must use Q.933a encapsulation if connecting to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment

2 Answers  

---

How do you disable CDP on the entire Router? A.) Router#no cdp run B.) Router(config-if)# no cdp enable C.) Router(config)# no cdp enable D.) Router(config)# no cdp run

1 Answers  

---

What is the Function of Router?

5 Answers  

---

Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom

1 Answers  

---

Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end B.) Half duplex transmission between stations is achieved by using point to multipoint Ethernet and Fast Ethernet C.) With Half Duplex transmission logically circuits feed into a single cable creating a situation similar to a one way bridge D.) Half Duplex transmission between stations is achieved using Point to Point Ethernet & Fast Ethernet

1 Answers  

---

In which protocol supenetting is enable by default?

0 Answers  

---

You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router

3 Answers   TCS,

---