IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?

2 Answers  

---

which supply is used in traction system

3 Answers  

---

132 KV TRFO BUSHING CT BURNT WHEN A 6.6KV HAS BEEN APPLIED TO IT .WHY .ANY REASON ?

3 Answers   vguard,

---

What is the better way of passing 400 amp from sending end to receiving end ? By overhead line or underground cable and why ? if underground cable then how much depth require ?

1 Answers   Aditya Birla, HCL,

---

Whether the Dc motor Droping the power factor like AC motor if lot of motor running in factory is it necessary to connect capacitor bank

2 Answers  

---

---

What is the formulae of Megger value for a A.C.Motor

0 Answers  

---

Can anyone explain me about the capacitor calculation

0 Answers  

---

1. alternator has full load regulation of 4% when pf of the load is 0.8 lag, 1500 rpm. full load regulation of 1400 rpm for 0.8lag will be ________ ?? 2. torque angle of a sync m/c operating from a constt voltage bus is usually defined as space angle between _______ . 3. method most effective in finding out no load losses in large DC shunt motoris ______ . 4. current carrying capacity of fuse material depends on ______ . 5. coil has res. 10 ohm, inductance 1H. what wil be current after 0.1sec after switching on to a 500V DC SUPPL ? ? 6. effect of phase lag compensation on servo systems ___________ . 7. rotor of a dc machine is usually supported upon ______ . 8. DC motor is preferred to AC motor in which application ?? 9. 3 nos of 10:1 Xmer are connected in Star-Delta to supply a load at 230V.the supply voltage must be ______ . 10. voltage source produces max current in which circuit. 11. cal. power, if current and voltage are out of phase by 90 degree. 12. suitable length of Xmission line of power at 66 KV. 13. Which of the theorm helps in simple computation when the load across a ckt is varying ?? 14. what is the adopted line length for power Xmission of power by cables ??

5 Answers   TATA,

---

Describe Non I.S. Earth System and why is it used?

0 Answers   KPJV,

---

why there is a 2 slits in three pin's earthing pin?

1 Answers  

---

our industries ht line so power fluctation(once drop of power please rectify causes

0 Answers  

---

How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?

0 Answers  

---