Answer / 7207502748

Examining the following factors should allow for a reasonable evaluation of cooling towers:
1) Purchased cost
2) Installed cost
3) Fan energy consumption
4) Pump energy consumption
5) Water use
6) Water treatment costs
7) Expected maintenance costs
8) Worker safety requirements
9) Environmental safety
10) Expected service life

Answer / 7207502748

Evaluating cooling tower bids should be compared following Factors-

* Fan energy consumption

* Pump energy consumption

* Purchased cost

* Installed cost

* Water treatment costs

* maintenance costs

* safety measurements

* Environmental conditions

What is a good method of analyzing powders for composition?

0 Answers  

---

To how much height the liquid willbe thrown out to atmosphere from a pump with a discharge pressure of 5bar

4 Answers   TCL,

---

How can you prevent bridging in a dilute phase pneumatic conveying system?

0 Answers  

---

My previous company dismissed from my job due to some reason. But they have given 1 year experience certification. But i worked for 1 year 4 months, How do i answer if interviewer asked what did you do for six months.why are you leaving your job?

4 Answers  

---

What is the maximum recommend pipe velocity for dry and wet gases?

0 Answers  

---

What are the main terms in unit operations? What are its characteristics?

0 Answers  

---

Question 73 - (a) A dryer reduces the moisture content of 100 kg of a potato product from 80 % to 10 % moisture. Find the mass of the water removed in such drying process. (b) During the drying process, the air is cooled from 80°C to 71°C in passing through the dryer. If the latent heat of vaporization corresponding to a saturation temperature of 71°C is 2331 kJ / kg for water, find the heat energy required to evaporate the water only. (c) Assume potato enters at 24°C, which is also the ambient air temperature, and leaves at the same temperature as the exit air. The specific heat of potato is 3.43 kJ / (kg °C). Find the minimum heat energy required to raise the temperature of the potatoes. (d) 250 kg of steam at 70 kPa gauge is used to heat 49,800 cubic metre of air to 80°C, and the air is cooled to 71°C in passing through the dryer. If the latent heat of steam at 70 kPa gauge is 2283 kJ / kg, find the heat energy in steam. (e) Calculate the efficiency of the dryer based heat input and output, in drying air. Use the formula (Ti - To)/(Ti - Ta) where Ti is the inlet (high) air temperature into the dryer, To is the outlet air temperature from the dryer, and Ta is the ambient air temperature.

1 Answers  

---

Explain what is a quick way to calculate frictional pressure drops in carbon steel pipe?

0 Answers  

---

What is a 'saltation velocity' and how is it used in designing pneumatic conveying systems?

0 Answers  

---

Are there any general rules that should be considered when designing a slurry piping system?

0 Answers  

---

Question 46 - In a steady state one dimensional conduction with no heat generation, the differential equation is d / dx (k dT / dx) = 0. Prove that T(x) = ax + b, where k, a and b are constants. (b) At x = 0, T = c and at x = L, T = d. Prove that T(x) = (d - c) x / L + c for boundary conditions.

1 Answers  

---

What is the process of Scrubber ?

3 Answers  

---