Which command displays the intenances using a given access list? A. show filters B. show ip interface C. show active lists D. show interface paramaters E. configure ip access lists F. show access-list interfaces

1 Answers  

---

I am just getting into this,I want to jump ahead a do the packet tracers in discovery working at a small to medium business or ISP but I am trying to get the last lab putting it all together. Does anyone have anything for this. I know it is ahead of me but I would like to get this so I can look at the beginning and understand it more

2 Answers  

---

Which statement is true? A. While bridges are used to segment networks, they will not isolate broadcast or multicast packets. B. A bridge looks at every packet within its network segment and works like a hub re-broadcasting the packet if the destination is within its network segment. C. A bridge maintains a table of the IP addresses of the hosts within its network segment and forwards the packet directly to the destination based upon the IP address. D. A bridge resets the hop count by keeping all packets within the network segment. Only packets addressed to a specific destination host outside the network segment are allowed to pass through the bridge.

1 Answers  

---

What is the function of the Transport layer and which protocols reside there? A.) MAC addressing - IP B.) Interhost communication - SQL, NFS C.) Best effort Packet delivery - TCP, UDP D.) End-to-end connections - TCP, UDP

2 Answers  

---

Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp

1 Answers  

---

What is the IEEE specification for Spanning Tree Protocol? A.) 802.9 B.) 803.ud C.) 803 D.) 802.1d

1 Answers  

---

Identify the command that configures the bandwidth to 56K? A.) Router(config-if)# bandwidth 56000 B.) Router(config-if)# bandwidth 56k C.) Router(config)# bandwidth 56 D.) Router(config-if)# bandwidth 56

1 Answers  

---

what is subnet mask?

5 Answers   HCL,

---

What is the maximum hop count for Link-State protocols? A.) 15 B.) there is no hop count limit C.) 256 D.) 16

1 Answers  

---

What is VLSM? how to Calculate VLSM? where it is use and why?

13 Answers  

---

When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30

1 Answers  

---

how many pass word you can configure on cisco 2500 router

3 Answers   HCL,

---