WAN stands for which of the following?
A.) Wide Arena Network
B.) World Area Network
C.) Wide Area News
D.) Wide Area Network
Answers were Sorted based on User's Feedback
Why would you use static routing instead of dynamic routing? A.) When you want automatic updates of the routing tables B.) All the time C.) When you have very few routes and want to conserve bandwidth D.) When you have a gateway of last resort
In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physical interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay
Which 2 commands shows the Cisco IOS filename? A.) show IOS B.) show ver C.) show flash D.) show mem E.) show NVRAM
Which command do you use to set the Secret password to 'roundwood'? A.) enable login roundwood B.) enable password roundwood C.) enable privilege roundwood D.) enable secret= roundwood E.) enable secret login roundwood F.) enable secret roundwood
Which of the following is used to manage and monitor the network? A.) SNMP B.) HTTP C.) IP D.) FTP
What is bia?
After how long eigrp protocol advertise its routing table?
Which layer hides details of network dependent information from the higher layers by providing transparent data transfer? A.) Transport B.) Physical C.) Data Link D.) Session E.) Application F.) Network
Identify the order of the 5 step encapsulation? 1. Create the segment 2. Convert the frame to bits 3. Create the packet 4. Create the frame 5. User creates the data A.) 1,2,4,2,5 B.) 2,1,3,4,5 C.) 5,1,3,4,2 D.) 5,3,4,1,2
Identify the 2 characteristics regarding MAC addresses? A.) Contains a network portion and host portion B.) Always assigned by System Administrator C.) 48 bits long D.) Contains a vendor code and serial number
Which 3 statements describe default encapsulation and LMI type configuration? A.) There are only four encapsulations and 3 LMI type options B.) The LMI type config term options C.) In release 11.3 the LMI type is autosensed D.) The default LMI is Cisco E.) IETF encap must be configured unless the connecting routers are both cisco
What is a key use of a device hardware address? A. to obtain a vendor code / serial number from the user B. to transmit a frame from one Interface to another Interface C. to transmit a packet from one local device to another local device D. to transmit data from one local device to a remote device across the internet E. to contain logical information about the device to use for end-to-end transmission