Identify the definition of demarcation?
A.) Date in which the WAN service contract expires
B.) Cabling which extends from the WAN service provider to
the customer
C.) Division of responsibility, where the CPE ends and the
local loop
begins
D.) Equipment which is located at the customer premises
- 1 Answers
- 3891 Views
- I also Faced
- E-Mail Answers
hi jitendra i am sunil here and i am an engineering student from delhi i have lots of interest in computer network.i was in serch of doing communication through MAC adressess.can u help me?
hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku
Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Route# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes
What information can you get from CDP info: (choose all that apply) A.) Hardware platform B.) One address per protocol C.) Software platform D.) Hostname E.) The same info as show version F.) Incoming/outgoing port
How to see the running-config & startup-config infor from global configuration mode. As we know, from priviledge mode we cn see it by executing command. i.e. Router#show running-config and Router#show startup-config Now wat is the coommands use in global configuration mode o see those info. Router(Config)# ??????
Which command we give if router ios stucked?
Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc
Identify 3 feature of access-lists? A.) Implicit deny will deny any packets not matched B.) Processed sequentially from bottom to top C.) Processed sequentially from top to bottom D.) If a packet is denied it would be tested against the remaining statements in the access-list E.) Once a match is made the packet is either denied or permitted F.) Enabled on all interfaces by default
What is the frame relay, in which layer it comes?
What is the Difference between Switch and Bridge?
Tell me which protocol works only on cisco routers?
What is VLSM ?
CCNA 
