Suppose a Switch interface went in error-dis mode what you will do for Troubleshooting List all Possibilities

0 Answers   Infosys,

---

R1#sh ip nat translations Pro Inside global Inside local Outside local Outside global icmp 15.1.1.1:11 10.1.1.1:11 30.1.1.1:11 30.1.1.1:11 icmp 15.1.1.1:12 10.1.1.1:12 20.1.1.1:12 20.1.1.1:12 icmp 15.1.1.1:13 10.1.1.1:13 21.1.1.1:13 21.1.1.1:13 icmp 15.1.1.1:14 10.1.1.1:14 31.1.1.1:14 31.1.1.1:14 R1# So my question is that after every ip address [:] is used & some number. 15.1.1.1{:11}... what is this colon & number indicate. Can anyone tel me this..!!! Thanking you advance. Shahin

4 Answers  

---

Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end B.) Half duplex transmission between stations is achieved by using point to multipoint Ethernet and Fast Ethernet C.) With Half Duplex transmission logically circuits feed into a single cable creating a situation similar to a one way bridge D.) Half Duplex transmission between stations is achieved using Point to Point Ethernet & Fast Ethernet

2 Answers  

---

Explain how many types of router?

0 Answers  

---

Which protocol switch use for filling its mac-table?

0 Answers  

---

What are the generic parts of a network layer address? A. an intenetworks number and a URL B. a vendor code and a serial number C. a network number and a host number D. a broadcast number and a unicast number E. a domain identifier and a device identifier

1 Answers  

---

how we update the IOS version with the help of TFTP?

0 Answers  

---

I have layer 3 Cisco 3560(Multilayer) switch right.How we can configure sub interface & Inter VLAN(we have vlan 2,3 & 10 ),Each VLan talk with each other?

4 Answers   IBM,

---

Explain the difference between baseband and broadband transmission in ccna?

0 Answers  

---

In which three situations is a hold down timer reset? (Choose three) A. when the hold down timer expires B. when infinity is finally defined as some maximum number C. when the router exchanges update summaries at area borders D. when the router detects faulty LSPs propagating through the internetwork E. when another update is received indicating a new route with a better metric F. when another update is received indicaing the original route to the network has been restored G. when the router receives a processing task proportional to the number of links in the internetwork

1 Answers  

---

How do you set the encapsulation type to PPP for an interface? A.) encap ppp B.) ppp encapsulation C.) encapsulation ppp D.) encapsulation ppp enable E.) ppp enable encapsulation

2 Answers  

---

Significance of IP helper-address Command on SW? Is it necessary to put this command?

1 Answers   Accenture,

---