What device has content-addressable memory (CAM) and what is stored in it? 1 A: Switch, learned IP addresses 2 B: Router, learned IP addresses 3 C: Switch, learned MAC addresses 4 D: Router, learned MAC addresses

4 Answers  

---

Given an IPX network with redundant paths, what command will configure load balancing? A.) ipx load-balance B.) ip maximum-paths 2 C.) ipx maximum-paths 2 D.) ipx load-share

2 Answers  

---

Which OSI layer supports the communication component of an application? A.) Data-Link B.) Physical C.) Session D.) Presentation E.) Application F.) Transport

2 Answers  

---

Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch

3 Answers  

---

Identify the type of routing protocol that exchanges entire routing tables at regular intervals? A.) Link state B.) Interior gateway protocols C.) Appletalk routing D.) Distance vector

1 Answers  

---

---

Which protocol supenetting is enable by default?

0 Answers  

---

Which dynamic type draw back is, if single link down, it removes its routing table?

0 Answers  

---

What is the difference between half duplex and full duplex?

0 Answers  

---

Which two of the following protocols are used at the Transport layer? A.) ARP B.) UDP C.) ICMP D.) RARP E.) TCP F.) BootP

1 Answers  

---

Identify the 2 methods to modify the routers boot sequence? A.) Setup program B.) Boot system commands C.) RXBoot D.) Config-register

1 Answers  

---

Identify the 2 commands to copy a configuration from a TFTP server to RAM? A.) configure network B.) configure overwrite C.) copy backup-config running-config D.) copy tftp running-config

2 Answers  

---

Which command displays access list 111? A. show access-list 111 B. show ip access-list 111 C. display ip access-list 111 D. display access-list 111 details

6 Answers   Satyam,

---