Which three commands are used to configure information into RAM on a router? (Choose three) A. configure memory B. configure terminal C. configure overwrite D. copy tftp startup-config E. copy running-config startup-config F. copy startup-config running-config

8 Answers   HCL,

---

Which command verifies encapsulation as well as Layer 1 and Layer 2 statistics on a router configured for Frame Relay? A. show ip B. show interface C. show statistics D. show frame-relay

1 Answers  

---

What is HSRP and what is difference between HSRP and GLBP

2 Answers   Infosys,

---

What does the meaning of <cr >?

0 Answers  

---

What does the ping response & mean? * A: unreachable * B: congestion * C: user interrupt * D: unknown packet type * E: lifetime exceeded

6 Answers  

---

'Show cdp neighbors detail' show the following 3 pieces of information? A.) Hardware platform B.) Software version C.) Same as 'show version' command D.) Up to 1 address for each protocol E.) Non-direct connected routers

2 Answers  

---

thnx jitender...its me shridh...m working for SG ltd..the situation iz like ths -at a specific time in our company the internet connectivity goes off...v hav two networks in our company...but out of it only one link goes down for 5-10 sec...a fastethernet port becomes down for few sec and automatically becomes Up... Is this occures becoz of Power?? If yes thn y the 2nd network is not affected?? plz tel me jitender how to resolve ths problem? as u sd loop in switch is the primary cause of ths....i wanna know how to resolve it...thnx for ur replys jitender sinha.

2 Answers  

---

Which type of switching is considered to be 'wire speed?' A.) Cut-Through B.) Multiplexed C.) Inverted D.) Layer 4 E.) Store and Forward F.) Layer 3

2 Answers  

---

In Novell's use of RIP, there are two metrics used to make routing decisions. Select the two metrics. A. Ticks. B. Hops C. Loops D. Counts

3 Answers  

---

Mention what is the difference between dynamic ip and static ip addressing?

0 Answers  

---

Can u convert an ethernet port to a serial port (or) vice versa ?

2 Answers   ADP,

---

thnx Jitender singh...as u told to install a stp in switches and problem vil b get solved...i wanna kno how to install stp in switches?? plz tel me detailled steps... thanx for ur answer.

1 Answers  

---