hello i am new to this, i need to know how will i complete a basic scenario that ask the required number of networks that is 80 and the minimum number of host that is 3000 and the network address is 10.0.0.0 and i need to need how to compute to get the answer on what is the subnet mask.

3 Answers   Kaplan,

---

In regards to the ISDN BRI standard, which channel is used for control? A.) B B.) D C.) E D.) I E.) Q

2 Answers  

---

What is required to support full-duplex Ethernet? A.) Multiple paths between multiple stations on a link B.) Automatic sensing operation by all connected stations C.) Loopback and collision detection disabled D.) Full-duplex NIC cards

1 Answers  

---

Which layer defines bit synchronization? A.) Application B.) Network C.) Transport D.) Physical E.) Session F.) Session

2 Answers  

---

Hi, Jitendra/Shahin You both are masters of networking na. I am worrying about my exam. Is it vey tough?because my friend got failed in ccna. he is very talented person thogh he failed.

1 Answers  

---

---

You have two Cisco routers setup back-to-back in a lab using DTE/DCE cables. To which router would you add the clockrate command? A.) The serial port on the DCE router B.) The Ethernet port on the DTE router C.) The Ethernet port on the DCE router D.) The serial port on the DTE router

3 Answers   TCS,

---

Does a bridge divide a network into smaller sections?

0 Answers  

---

What is the point-to-point protocol in ccna?

0 Answers  

---

In Novell's use of RIP, there are two metrics used to make routing decisions. Select the two metrics. A. Ticks. B. Hops C. Loops D. Counts

3 Answers  

---

What is protocol data unit in ccna?

0 Answers  

---

Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router

1 Answers  

---

Brielfly explain the conversion steps in data encapsulation

0 Answers  

---