Of the following switching types, which one has the highest
latency?

A.) Cut-through

B.) None

C.) Store-and-forward

D.) Fragment Free



Of the following switching types, which one has the highest latency? A.) Cut-through B.) None..

Answer / guest

Answer: C

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More CCNA Interview Questions

4. What is a disadvantage to using bridges in your network? A. Filters by MAC address B. Stops broadcast storms C. Doesn't stop broadcast storms D. Can only use up to 4 bridges in any LAN

3 Answers   NCTC,


In port based access-list which command you give instead of ip?

0 Answers  


Explain the term 'broadcast'.

0 Answers  


Which two encapsulation names are correctly paired with the Cisco IOS encapsulation names? (Choose two) A. Ethernet_II-ARPA B. Ethernet_802.3-SAP C. Ethernet_802.2-LLC D. Ethernet_SNAP-SNAP

1 Answers  


Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) Booter load D.) RAM E.) Flash

2 Answers  






What is etherchannel?

0 Answers  


Which device works at the Network Layer of the OSI model? Router Switch Bridge Hub

5 Answers   CET, IBM,


What was the key reason the International Organization for Standardization released the OSI model? A. users could access network servers faster B. different vendor networks could work with each other C. the industry could create a standard for how computers work D. network administrators could increase the overall speed of their network

1 Answers  


Which line from a show spantree 1 command output indicates that virtual LAN 1 (VLAN1) is functioning properly? A. Root pod is FastEthernet 0/26 B. Port Ethernet 0/1 of VLAN1 is Forwarding C. Designated port is Ethernet 0/1, path cost 10 D. Designated root has priority 0 address 00D0 588F B600 E. VLAN1 is executing the IEEE compatible Spanning Tree Protocol

1 Answers  


What is the difference between RIP & RIPng???? Can anyone explain it..!!! Thank u in advance.

1 Answers  


why we use AS no. in IGRP and EIGRP?

2 Answers   HCL,


What does the 'S' mean when looking at the routing table? A.) Statically connected B.) Directly connected C.) Dynamically attached D.) Shutdown route

2 Answers  


Categories