For polarity test on a 11/3.3kV 2.5MVA delta-star Unit Auxiliary transformer,415V 3-phase supply was applied at the HV. Connection between Aa was made with a 2.5mm cable. As soon as power was switched on the cable caught fire and burnt. This test was then abandoned. It is noteworthy to say that a similar cable was also used in a similar transformer for the same. The cable did not burn and test was successfully completed with good result. What is wrong? Please, help me out.

3 Answers  

---

what is meant by transformer oil temparature

3 Answers   Vijaya Bank,

---

What are the types of piano switches?

0 Answers  

---

WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >

0 Answers  

---

What are armoured cables?

2 Answers   IOCL,

---

In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.

0 Answers   Kaytech,

---

How much UG cable size should i use so as to accomodate a ground + 2floors house. A 1.5ton AC & geysers(2) in each floor with lightings

2 Answers  

---

WHAT IS DIFFRENCES DCS & PLC

1 Answers   Essar,

---

what is the ciruit diagram of transformer vector grup test?

4 Answers   Green Power,

---

Recently we had experienced following problem All RCCB breakers (connected to the load as well as spares) connected to various UPS systems at various floors at a high rise building tripped during a power break down and upon starting up of generator.This Generator is recently inducted into the installation. Can any one explain the reason behind this tripping. Regards Viswanathan

1 Answers  

---

Difference between transition and diffusion capacitance

0 Answers  

---

What are the commonly used schemes for the bus zone protection?

0 Answers  

---