if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos

if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.

Question Posted / sohail ahmad khan

0 Answers
1594 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

Draw SLD for a panel has 500A Bus Bar rating, with 4 outgoing, each is 80 A (load current), showing the transformer and capacitor bank rating.

0 Answers FEWA,

what is the name of oil used in transformer

11 Answers Energy Pack, Genco,

what is saturation kit?which use above 15 kw motors panel side.

0 Answers Power Grid,

HOW TO CALCULATE GROUND FAULT CURRENT IN 430V 4000AMP AIR CIRCUIT BREAKER?

2 Answers

what is the principle of operation of tungstun bulb ??

0 Answers

Difference between single phase and three phase?

1 Answers

What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?

0 Answers

How can two 3 phase transformers of same KVA and Voltage be connected in parallel?

0 Answers Bernhard Schulte Shipmanagement,

What do you mean by pull of electromagnet?

0 Answers

what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?

0 Answers

WHY WE ARE DOING THE EARTHING IN A SYSTEM. SOME PEOPLE ARE TELLING FOR PROTECTION. WHAT PROTECTION GIVE ME THE CORRECT ANSWER.

2 Answers

what is load flow?

2 Answers

For more Electrical Engineering Interview Questions Click Here