Interested to Buy Any Domain ? << Click Here >> for more details...
Do you know how to connect a motor of different H.Ps?
- 5 Answers
- 13910 Views
- I also Faced
- E-Mail Answers
Answer Posted / ecb 04-03-06
a motor of different h.ps can be connected by use of drives
by diff. gear ratios power can b edistributed &as well can
be asemble
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
Explain how you intend to work under pressure to meet up with deadline target?
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
how to calculate the formula of cable size if motor kw is given
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
IN dc capacitive reactance is??
how we arrange the hv side with delta connection in case 33/11kv of transformer.
what is settable hystersis protection? If any body knows plz kindly post the answer..
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
How to check the LM324 Ic
1hp= how much rpm
can i use the six sigma method which is used in management area, in state estimation of power systems?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
