Do you know how to connect a motor of different H.Ps?
- 5 Answers
- 12289 Views
- I also Faced
- E-Mail Answers
Answer Posted / pillay
I think you were asked about a motor that can be connected
differently to get a different HP rating. You have to rely solely
on the connections options given on the name plates or the
manufacturer.Sometimes the same motor can be connected for
different RPM and different HP.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?
What is the actual calculation for transformer short circuit test?.
what is the circulate the diesel in DG in side pls tell parts name and picture with circulate the diesel
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
Ceiling Fan and Storage type water heater. Discuss
how we calculate the withstansing current capacity of wires&cables?
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
How impulse levels are calculated that for 11kV impulse is 75kvp, for 24kV impulse is 125kvp ?
what is the pulse and audio frequency transformer? what is different between induction regulators and tap changing transformer?
what is the difference between directional & non directional earth fault with example please explain.
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
How to calculate VCB rating for 33KV ,25 MW Power line?
