Answer / vinod kumar patel

60 bag inratio1:4:6&55bag in 1:5:6

how to do rate analysis for P.C.C 1:4:8 for 2.83cum(100cft)

2 Answers   Unity Infraprojects,

---

how much cement and sand required for 1cum rr masonry

0 Answers  

---

1 TMC Equal to how much Cusec

0 Answers  

---

Why compressive strength of only concrete cubes and cylinders tested ? why not other shapes?

1 Answers  

---

i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?

0 Answers   Public Service Commission,

---

Is there any difference in IS 456 and IRC 15? 

1 Answers  

---

Civil engineering

1 Answers   MEIL,

---

Instead of sand blasting is there any method to clean the rust of steel ???

2 Answers   L&T,

---

what is irrigation

2 Answers   Era Infra Engineering, Prothious,

---

what would be compressive strength of cube for 7 days if design mix of M15

1 Answers  

---

In a beam,stirrups are placed closely at ends than at centre due to shear.similarly where would ties be closer to each other-at center or at ends in a column and slab.

0 Answers  

---

A bill was raised by contractor which read as follows 1.) Excavation in normal soil upto 1.5m - 250 cum 2.) Excavation in normal soil 1.5m to 3m - 240 cum 3.) Excavation in soft rock - 350 cum 4.) Excavation in hard rock - 250 cum 5.) Filling with available soil - 825 cum 6.) Filling with bought out soil - 1100 cum How can I verify the above quantities, especially for item no. 5 & 6? What checks are necessary before releasing the bill ?

5 Answers  

---