they transformer oil leakeage to beather tank and top parts . they protection relayes was not operated.what is the oil leakeage problem.



they transformer oil leakeage to beather tank and top parts . they protection relayes was not operat..

Answer / raja.k

Over filling of oil than maximum level

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

WHEN THESE TRANSFORMERS WINDINS CONFIGURATION ARE USED? SPECIALLY EXPLAIN REGARDING STEP UP AND STEP DOWN KEEPING IN MIND.AND REGARDING LOAD ALSO. a.star to delta b.delta to star c.delta to delta d.star to star ALSO EXPLAIN WHY V USE 415/415 TRANSFORMERS IN TUBEWELLS?

1 Answers   ABB,


Dear Sirs, I am a technical persons.In one of our Electrical Sub- Station, We have installed three numbers of 1250KVA ,11KV/0.415KV Transformer to feed the Factory load. We have found some abnormality. In one of our Transformers the leakeage current from transformer body to earth through earth continuity wire is almost 86 Amp but in other transformer it is (5-10)Amp. where the load current on three phase and neutral are respectively 1360Amp,1400Amp,1370 Amp & 176Amp. So please any technical person help me about the reasons of this situation and how I can rectify the fault. Moreover,I have measured the earth resistance of the Earth continuity wire which is less than 1 Ohm. Thanks Tapas Barua

3 Answers  


What is the equivalent circuit of a transformer and its vector diagram?

0 Answers   Bhel, Madhucon,


What is the difference between Floot charge and Trickle Charge.

1 Answers   Torrent Power,


what is bus coupler? and how many type? which one is big advantage ?

2 Answers   Essar,






what type of euse we should use ? 1- High resistance & low temperature 2- High temperature low resistance

2 Answers  


what is the difference between droop mode and ischnorous mode in thermal powerplant?

0 Answers   GVK, Thermax,


Can you any explain about active,reactive and apparent power in power system with example.

1 Answers  


what will be happened when a single phase motor is supplied by the dc supply

3 Answers  


why 15 kw motor winding resistance is low then 5 kw motor winding resistance?

0 Answers   Baosteel,


HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????

0 Answers   General Electric,


if the voltage across the lamp drops by 1%, the power drawn will be reduced by how many %?

5 Answers   PSPCL,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)