how can change 10mm dia @275 c/c bar spacing to 12 mm
Answers were Sorted based on User's Feedback
Answer / anusha
Spacing is directly proportional to square of diameter, so
X/275 = 12^2/10^2
X= 396 mm c/c
as per IS 456:2000, spacing should not be greater than 300mm
X = 300 mm
Is This Answer Correct ? | 6 Yes | 1 No |
Answer / s k majumder
10/275 = 12/x
x= 330 mm
As dia increase spacing will be increase. however better to spacing limited to 300mm
Is This Answer Correct ? | 6 Yes | 4 No |
how to determine the correctness of proportion used in cement mortor and various IS codes to determine the same?
what is civil engineer greatest strength and weakness?
what is the load bearing capacity of the scafolding pipe (50mm) and other.
In the cement the compound quickest to react with water
form work including the props can be removed from beams only after
What is Pavement & carrage way?
what is a coupler and where do u use it ?
can any1 mail me IS CODES and quality check sheet of materials..? its urgent plz
What is the per cu. mt. price of ready mix in Gujarat region.?
How calculate the physical stock of material such as Fine/Coarse aggregate,sand & stone dust laying at site?
if rise and tread of stairs rae 16 & 25cm with landing slab of thickness 100mm . If there are 8steps, and carpenter ask for to mark the bottom of centering of landing on column, what will be the height above floor finished level?
What is approximate % of wastage considered for Marble and vitrified tiling works (flooring)?