how can change 10mm dia @275 c/c bar spacing to 12 mm
- 4 Answers
- 13812 Views
- MEIL, I also Faced
- E-Mail Answers
Answer Posted / anusha
Spacing is directly proportional to square of diameter, so
X/275 = 12^2/10^2
X= 396 mm c/c
as per IS 456:2000, spacing should not be greater than 300mm
X = 300 mm
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
How much quantity of cement and sand required for the inlining of 610mm dia MS pipe 8.7mm thk.Inlining thickness is 10mm and CM ratio is 1:1.5.
Why joints are provided?
What is thumb rule for deep trench excavation
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
What will be weight of 0.5mm GI sheet per sq.ft?
What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.
find the discharge of water through a horizental venturimeter having 400mm dia at the inlet main and 150mm dia at thorat.if the diffrential gauge between inlet and thorat shows a pressure head of 25cm mercury. assume coefficient discharge 0.98 and specfic gravity of mercury as 13.6.
What is the frequency of sampling for the materials of cement,Fine aggregate, Coarse aggregate .and refer which code
how many types of survey and what are levelling instrument?
What is packing Factor ?
1)Why we can use half brick in 4inch wall and 2)why not in 9+inch brick wall
how many running meters in one kilogram of 4mm pvc coated chainlink fencing
List out some of the software used in the construction sector to estimate cost and monitoring expenses?
What is 1/8 on the architect ruler denotes?
How to get MEP technical,instaaltion & testing data for interview?
