Answer / naresh

ACCURACY is the degree of closeness of measured value to the true value


PRECISION getting the same result for same inputs for n number of iterations

an instrument may not be accurate but precise. i.e it may not give the correct value but it will give the same answer when same inputs are processed

Answer / vijay patel

Accuracy is degree of closeness of measured value to the true value.

Answer / reddy

Accuracy refers to the closeness of the measured value to the standard value
Precession refers to closeness of the two measurements to each other

Answer / chiragmodi07@gmail.com

If instrument accuracy is good than it's preciseness is also good, but if preciseness is good than it doesn't means accuracy is also good.

Answer / uday

Accuracy refers to the closeness of a measured value to a standard or known value.

Precision refers to the closeness of two or more measurements to each other.

Answer / faiyaz ahmad

Accuracy- is how close measure value to actual value that is called accuracy

Pre-cession-is measure anything indifferent different time that difference is called pre-cession

Hi at present i m wrking with tire industry as a manager having gud ctc. Nw I am selected for 1 of the best chemical industry but my ctc is lower than current n also i hv 2 compromize vit post as post is also lower. I hv 6 yrs of exp in various type of industry. Should i join chemical industry as there ar lot of gud instrument than tire? Financialy i can manage 4 more 2 yrs. Bt during wrking vit tire industry i found there is very less instrument n feel that opportunity is less. Pl ans quickly. I have less time to decide.

1 Answers  

Full form of KKS when use DCS.

0 Answers  

WHY WE R NOT USING THE TURBINE FLOW METER IN THE STREAM SERVICE ? pl explain?

3 Answers  

How to connect PLC to DCS ?

2 Answers   Alkyl Amines,

what will be the principle & application of dissoled oxygen analyzer at wast water treatment plant at oxidation basin & how it work?

1 Answers  

how do we commission inergen system?

0 Answers  

In dcs contol valve parameters showing like this Gain=1 or 2 , ti=7 sec, td=20sec. But temp,pressure,level control valves we are using in which type parameter side using ti,td clearly tell me

1 Answers  

Why ues 250 ohms Resistor during hart type instruments calibration with hart protocol in details ?

5 Answers  

HOW CAN I CONNECT ROSEMOUNT 3300 LEVEL TRANSMITTER TO Allen-Bradley SLC500

1 Answers  

How RAL(Rotary air lock)works in cement industry?

0 Answers   Jaypee,

what is working principle of presure and temperature guage?

4 Answers  

for oil & gas industries which zone is normally preferred? why? give its example?

0 Answers