Interested to Buy Any Domain ? << Click Here >> for more details...
difference between accuracy and precision
- 6 Answers
- 8532 Views
- Honeywell, ONGC, I also Faced
- E-Mail Answers
Answer Posted / reddy
Accuracy refers to the closeness of the measured value to the standard value
Precession refers to closeness of the two measurements to each other
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How to calibrate an pressure gauge with yantrika test bench?
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
what is exact time to study dcs and plc cources
what is difference between fork type and capacitance type level switch. where it is using
How to calibrate capillary type level transmitter
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
How do bending tubing provide better measurement than using tubing fittings such as elbows?
What is zener diode? What is voltage regulator?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Gas equation
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
how do calibrate the valves.. with clear manual
