On LPG sphere tank we used LIT for level indication.High side port is connected to the bottom of the tank while low side port connected to the top. I would like to know how to fill the glycerin on its low side with two condensing pot installed,one from top and the other one for its drain line.Please I need your expertise...thanks

1 Answers  

---

What are the different type of instrument used in cement industry with uses

2 Answers   Lafarge,

---

How many loops are there in the power plant? how many closed & open loop in the power plant ? Please give me the exact clarification?

2 Answers   Lanco, Reliance,

---

How to measure density of oil in your kitchen. i.e indirectly to verify the quality of oil using min. gadgets available in the kitchen/house.

1 Answers   HPCL,

---

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers   OPaL,

---

what should be the distance of vibration sensor & to the point where vibration to be measured Ex turbine axial displacement

3 Answers  

---

why using negative supply for bentley nevada vibration system ?

0 Answers  

---

Why mixer nd grinder Is example of constant torque load not variable torque load ???

0 Answers  

---

What is meant by Fail Safe Condition in PLC?

4 Answers  

---

What is PDS and PDMS ?

0 Answers  

---

How LVDT position transmitter works on DC supply(24vdc) from DCS, whereas transformer operates on AC supply? pls help..

1 Answers  

---

I have installed a RTD whose length is 2250mm(RTD stem length), but it's upper 200 -250mm is out of the reactor, and this upper 200mm stem is surrounded by atmospheric temp. And the lower portion i.e. 2000mm is in contact with the measuring fluid, then does the final measuring temp. Gonna change as the upper 200mm RTD stem is out of reactor?

1 Answers   Process Control Technologies,

---