Answer / tapas

KWH is always a consumption. Means its the difference of running value to previous value for a particular time period.

If here consumption is 77 KWH in 2 hours then KW=KWH/Hr

KW= 77/2= 38.5 KW

So for KWH time period should be mentioned.

Answer / aruniscool

You should know the meter constant that's the ct ratio used to measure than u will get the reading.

1.why we are using blocks in withoutgaplightning arrester 2.why we ar using bushing in withoutgap lightning arrestor

0 Answers  

---

What happens if the series current double?

0 Answers  

---

In case of a synchronous generator carbon brushes, some brushes expire before the others. Why is so? When all the brushes are installed at the same time, why don't thee expire at the same time?

1 Answers  

---

in thermal power plant the steam produced is made to cool after falling on the turbine blades. my question is why this is done while the same is needed to heat up again. "jab pani ko wapis garam hi karna hai to thanda kyu karte hai"

11 Answers   Bhel,

---

how can u determine size of the conductor by knowing the voltage level

2 Answers  

---

how much GROUND & NEUTRAL VOLT maintain in data center.

0 Answers  

---

A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.

0 Answers  

---

what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?

0 Answers   Thermal Systems,

---

If the Supply voltage is increased by n times, the cross section of conducter will [increase/decrease] by ________ times ?

4 Answers  

---

in what type of applications v can use q meter?

0 Answers  

---

During the transients in alternator,the mechanical power input remains almost constant while the electrical power output changes significantly.Why?

1 Answers  

---

WHY IS wet surface used for grounding???

2 Answers  

---