Why rating of transmission line in kv not in kva
Answers were Sorted based on User's Feedback
Answer / umesh
Transmission lines are rated in MVA they have there current limits also but the voltage which predominates in determining the heights,gap between wires etc. so ultimately we give ratings in KV.
| Is This Answer Correct ? | 2 Yes | 0 No |
If a fan get trip and run in reverse direction due to system flow. Now in this condition during starting how can a VFD bring this negative speed to zero and later run in forward direction?
2 Answers Aditya Birla, Siemens,
What Is HO factor in power selection
In some countries it is found that an Earthing Transformer is connected at the LV sides of the Transmission and Distribution Substation Transformers.Actually what is the purpose the Earthing Transformer?
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
what is the diff. b/w restricted earth fault relay & standby earthfault relay and where they are used?
4 Answers KSK Energy, Reliance,
what is MUSS?
Define piezo-electric effect?
Can we convert off line transformer to on line transformer
What is DTR erection?
i have a wire.and the current flowing in that.when we cut the wire then why dont we seen the elactrons....
how many bulb of 60watt at 300volt is used to maintain 0.25 amp.with valid reason?
WORKING PRINCIPLE OF HALOGEN LAMP & MEQUERY LAMP
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)