Do these factors (settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot)) are the part of first order, second order, higher order, linear, non-linear, open-loop, closed-loop, homogeneous & non-homogeneous systems ?

1 Answers   Limton,

---

Merits & Demarits of Oil circuit & Air circuit breakers ?

0 Answers   Genco,

---

what is Electrical BMS

3 Answers  

---

when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?

0 Answers  

---

comparision between mcb,mccb,elcb,flcb,elcb in details

0 Answers   ABB,

---

---

why lightining is not available in swith yards?

1 Answers  

---

What is the clear distance between a MV panel(rear side) and wall.

3 Answers   L&T,

---

When measuring the Insulation resistance of a motor winding (winding to earth) using a megger meter, Applied voltage(1000V) was automatically reduced to 500V. and the measured insulation resistance values are also very low (in Kohm range) Can anyone give me a reason???

3 Answers  

---

Can u Explain about the electronic trivector meter and the use of data converters in them?

0 Answers   Tricom,

---

what is the purpose of %impedance for transformer

3 Answers  

---

Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?

0 Answers  

---

Is itnecessary to use capacitor in an Fluorescent Tube Light Fixtures? Why? What if not capacitors are not included?

2 Answers  

---