Answer / bala

OLTC means On Load Tap Changer and It is coming with transformer. If it is fitted, no need to worry about the incoming voltage whether it is high or low as the transformer will automatically change its tap position to deliver the constant output voltage.This is possible only when we interface the AVR to it.

RTCC means Remote Tap Changer Control Panel. We can change the transformer tap position from remote area. This is possible only when the interfacing between OLTC and RTCC has been done.

Answer / prakash

1.OLTC stands for On Load or Off load tap changer. It is generally used in power jobs.In case
of Off load tap changer we must have shut down the transformer to change the tap
position but in case of On load tap changer we does not need to shut down the
transformer we change the tap position in running status of a transformer .
2.In case of on load tap changer a resistance is used to hold the current when we change
the tap position in running status of transformer for a short duration of time when tap is
change from one position to another if we not use the resistance the current is flow
back & coil is burnt.


RTCC stands for Remote tap changer controller .It consists of various switch i.e voltage up & down button ,tap changer button etc . It is connected to the transformer via OLTC and generally kept inside the substation for controlling the transformer and also all the important alarms are fit in it .so, we carefully look after the transformer by the help of it at a distance from the transformer

What is effect of harmonic current (Draw by VFD) on power system/ electrical Equipments ?

0 Answers  

---

what is the technical term when and alternator's prime mover fails.

3 Answers   DVC,

---

why is the transmission voltage is multiple of 11?

4 Answers  

---

What is tan delta & PPM in transformer? and whats its IS value?

0 Answers  

---

If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive

0 Answers  

---

how can you calculate fault level ?

0 Answers  

---

cable tray sizing & selection

1 Answers  

---

What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?

0 Answers  

---

What is the range of the stator resistance of 3 phase induction motor?

1 Answers  

---

For a CT the number of turns in the primary winding is.........

5 Answers  

---

what is meant by VDC ?where its applicable ?

2 Answers  

---

How supply comes to your home?

3 Answers  

---