Answer / pratyush

It will glow

Answer / arul raja.y

Because we will not connect proper earth in case any fault on earth line is passed to equipment.
You will be arrange the proper earth then you will connect the lamp between phase to earth.

Answer / rinkesh

It will glow
Due to potential difference so voltage iz available in this...

what is the difference between neutral

10 Answers  

---

why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)

0 Answers  

---

how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design

0 Answers   Amara Raja, TATA,

---

WHY MOSTLY BATTERY VOLTAGE IS IN MULIPLE OF 2 LIKE 2V,4V,8V,16V,18V....

2 Answers   Exide,

---

why phase to phase voltage are 290 rather then 440?

1 Answers   Bosch,

---

---

why single CT used in DOL starter power circuit?

0 Answers  

---

what is difference between vaccum circuit breaker and air circuit breaker?

2 Answers  

---

why we earth only one side of a power cable. And which side is advisable to earth.

1 Answers  

---

To determine the Healthiness of Insulation we will be performing Dielectric tests i.e Insulation Resistance test, Partial Discharge test,Switching Impulse, Lightning impulse, Tan Delta test ...etc why we required to perform this many test, why cant we do only one test. for Transformer, CT's

1 Answers  

---

If excitation will increase, then what will be the effect on power factor? Will it decrease or increase?

4 Answers   Prozone,

---

what is mean by PIR in circuitbreaker and give me detail of that?

0 Answers  

---

What is the Current equation in series RLC circuits.

0 Answers   ABB, Bhel,

---